What to do when stitch files do not resize correctly
Problem 1: Sometimes when you open a stitch file, some of the stitches may have been lost.
Problem 2: Sometimes when you resize a stitch file, some of the stitches may be lost or some of the special stitch effects are lost.
Why does this happen?
This will depend on how the original design was digitized and then saved. Some stitch files may actually be converted through several formats before it finally gets to you in the format you have. Each time it is converted, the quality could have degraded or some of the stitch types converted differently.
Solution: Open as stitches only, not recognized outlines
When you see this happen, Hatch Embroidery offers way to work around this!
Normally you open files to recognize as outlines of the object because this will give you more editing power in Hatch Embroidery. But, when you have designs where the outline of the object cannot be determined, it can give you either or both of the problems stated above. In this case, Hatch Embroidery allows you to open the design with "stitches only".
How to do this in Hatch:
1) When you open the design > find your stitch file type in the drop down list
2) Click "Options"
You will see the dialog box "Open Options" as shown below.
3) Click to select "Leave stitches as individual stitches"
4) Click "OK"
The design will open as stitch points only.
We recommend that you immediately save (export) the file and in the name indicate it as "stitches". DO NOT save over your original file.
Example: Original file name is "dog1.PES". Save (export) the file as "dog1_stitches.PES" before you start working with the design. if you then have problems or do not like what you have done, you can always revert back to the original file.
TOP TIP: Save the file as "dog1_stitches.EMB". When you do this, it will retain your edits, color changes, etc. Then after you are finished working with this design you can save (export) to "dog1_stitches.PES".
Other facts to keep in mind when you use this method:
1. When you open a file to leave as individual stitches, this will become the default when opening future designs. So when you go to open your next design, unless you wish to do the same, remember to follow those steps and open them as "Convert stitches into object shapes". This will then change to become the default.
2. I will generally first open designs with the usual "Convert stitches into object shapes" as this has more editing power. Only if this does not work, will I use the "Leave stitches as individual stitches". But this is a personal preference.
3. You will not be able to edit the design as much when opening as stitches only. Reshape is one area that will have limitations. While you can reshape by moving the single needle points with "stitches only", it is time consuming and uses a lot of computer resources. So it is really important to ensure you have saved your file and save often.
4. If you do need to edit stitch points, then do this last after all other changes have been made, such as resize, change colors, etc.
5. Resizing limitations: It is recommended that you only resize up or down by 10% when using a file with stitches only. Remember, it will not "add stitches or reduce stitches" based on the size, like an object file will. The current stitches stay and only get closer together or further apart. So you can see how you could lose "details" in the design and/or the design can get too dense".
6. This method is best used when you will make minor changes to the design.
7. It is recommended to change colors using the Resequence Docker color blocks.